Forums / Install & configuration / blank page after installation of ezpublish-3[1].0-2.zip (the previous version worked)
George P.
Wednesday 14 May 2003 1:20:36 pm
Hello,
I deleted a previous version of ezpublish 3 I had for tests and I copied to my site the content of new downloaded ezpublish-3[1].0-2.zip
Now I get a blank page instead of setup guide starts as before.
Anyone recognise the problem?
Karsten Jennissen
Thursday 15 May 2003 2:32:54 am
Did you enable the setup wizard? I'd rerun to get the configuration correct.
I got blank pages due to not enough memory but I am not sure that is the problem here.
Karsten
Thursday 15 May 2003 4:00:32 am
No, I didn't enable some setup guide. On my former installation this feature was by default enabled. Or am I wrong?
You can see my blank site here:http://www.interlingua.ro/publish/
Maybe it didn't like the new name for ezpublish directory (/publish/)?
Thursday 15 May 2003 4:24:21 am
Did you then install the new configuration files and update them with your actual configuration? You probably have some old config files sitting there that are not compatible with your new version.
The best way would be to delete any .php files found in the /settings/... and then check whether the setup wizard is enabled or not
Seehttp://ez.no/developer/ez_publish_3/documentation/ez_publish_3/howtos/enable_disable_the_setup_wizard
As I said, the PHP memory on my install caused blank pages. If it is at 8 or 10MB try setting it to 20MB or something like that.
http://ez.no/developer/ez_publish_3/documentation/ez_publish_3/typical_problems_and_solutions/not_enough_php_memory
HthKarsten
Thursday 15 May 2003 4:28:42 am
I deleted ALL and I began from scratch.
Thanks for the suggestion - I will check my setup file.
Regards,George
Script start
Module start 'content'
Module end 'content'
Script end
Time used to render debug report: 0.0002 secs